YUEQING WINSTON ELECTRIC CO.,LTD.
Yueqing Winston Electric Co., Ltd Proximity sensor,switching power supply,voltage stabilizer,motor soft starter,frequency inverter,float switch,AC magnetic contactor, thermal overload relay, terminal
Add to Cart
200mA Metal Proximity Ultrasonic Displacement Sensor PNP Overload Protected
Description
Ultrasonic sensors present the ideal solution for non-contact position and distance measurement in all industrial areas where environmental conditions such as dust, smoke or steam may affect the sensors. Objects consisting of a variety of materials can be detected to within millimeters regardless of color or shape.
Technical data
| General Specifications | |
| Sensing distance | 50…800mm |
| Adjustment range | 70…800mm |
| Unusable area | 0…50mm |
| Standard target plate | 100mm×100mm |
| Transducer frequency | About 255kHz |
| Response delay | About 100ms |
| Indicators/Operating means | |
| LED blue | Power on |
| LED yellow | indication of the switching state Flashing: program function object detected |
| LED red | permanently red: Error Red,flashing:program function,object not detected |
| Electrical specifications | |
| Operating voltage UB | 10…30VDC,ripple10%ss |
| No-load supply current | ≤20mA |
| Intput | |
| Input type | 1 TEACH-IN input Operating distance A1:-UB…+1V,operating distanceA2:+6… + UB Input impedance:＞4.7KΩ TEACH-IN programmable pulse :≥1S |
| Output | |
| Output type | 1 switch output E5,PNP NO/NC, programmable |
| Rated operational current | 200mA,short-circuit/overload protected |
| Default setting | Switching point A1: 70mm Switching point A2: 800mm |
| Voltage drop | ≤ 3V |
| Repeat accuracy | ≤ 1% |
| Switching frequency f | ≤ 4 HZ |
| Range hysteresis H | 1% of the set operating distance |
| Temperature influence | ± 1.5% of full-scale value |
| Ambient conditions | |
| Ambient temperature | -25…70℃(248...343K) |
| Storage temperature | -40…85℃(233...358K) |
| Mechanical specifications | |
| Connection | V1 connector(M12×1),4-pin |
| Material Housing | brass,nickel-plated |
| Transducer | epoxy resin/hollow glass sphere mixture; Polyurethane foam |
External synchronization
The sensor can be synchronised by the external application of a square wave voltage. A synchronisation pulse at the
synchronisation
input starts a measuring cycle. The pulse must have a duration greater than 100 μs. The measuring cycle starts with
the falling edge of a synchronisation pulse. A low level > 1 s or an open synchronisation input will result in the normal
operation
of the sensor. A high level at the synchronisation input disables the sensor. Two operating modes are available:
1. Multiple sensors can be controlled by the same synchronisation signal. The sensors are synchronised.
2. The synchronisation pulses are sent cyclically to individual sensors. The sensors operate in multiplex mode.
Internal synchronization
The synchronisation connections of up to 5 sensors capable of internal synchronisation are connected to one another. When
power is applied, these sensors will operate in multiplex mode.
The response delay increases according to the number of sensors to be synchronised. Synchronisation cannot be performed
during TEACH-IN and vice versa. The sensors must be operated in an unsynchronised manner to teach the evaluation limits.
Dimensions
Product picture